Replaces multi-section cans with 46 mm CTC mounting holes. Fits four 7.5 mm lead spacing, 16 mm diameter capacitors
This kit is intended as an easy way to replace old multi-section can capacitors around 1-3/8″ diameter (approx. 35 mm) with 46 mm CTC mounting hole spacing. These cans were often used in vintage audio and radio equipment, such as McIntosh, Marantz, Heathkit, and Dynaco.
The capacitor board fits up to four 7.5 mm lead spacing, 16 mm diameter radial capacitors. Smaller 5 mm lead spacing capacitors will also fit. An alternate version of this kit designed specifically for 5 mm lead spacing, 12.5 mm diameter capacitors is also available.
The negative leads of all capacitors are connected to a thick outer copper ring and two plated mounting holes. This means the negatives will be tied to chassis ground by default. If you need to isolate this board from chassis, take a look at our isolation kit.
Includes one capacitor mounting board, one spacer board, 5 wiring turrets (one extra), a mounting hardware kit, and a link to installation instructions. Capacitors are not included. In order to save on paper and toner, we are now including a link to a PDF copy of the installation guide. If you would prefer a hard copy, please let us know and we’d be happy to accommodate.
Based on the IPC-2221B standard, this kit is not to be installed in circuits that will see peak voltages greater than 600 V.
Specifications:
- Board material: FR-4 Kingboard KB-6165F (TG150, CTI >175)
- Board finish: HASL (Lead-free solder), matte black solder mask
- Copper thickness: 2 oz.
- Screw hole spacing: 45.95 mm center-to-center
- Screw hole size: 3.5 mm (#6-32 machine screw fits snug)
- Wiring/turret hole size: 2.4 mm
- Width: 55.39 mm
- Length: 39.50 mm
- Board thickness: 1.6 mm
- Height from surface of mounting board to top of a turret: 7 mm
- Spacer board diameter: 39.5 mm
- Spacer board thickness: 2.0 mm
- Capacitor lead spacing: 5 mm to 7.5 mm
- Max capacitor diameter: About 16 mm
- Capacitor lead hole size: 1.2 mm
- Diameter of turret’s hole: 1.63 mm
Note: Dimensions are nominal values. Outline dimensions may vary by ±0.15 mm, and hole sizes by ±0.076 mm
If you are interested, please contact us.